Đăng nhập Đăng ký

lớp phát sáng Tiếng Anh là gì

phát âm:
"lớp phát sáng" câu
Bản dịchĐiện thoại
  • Từ điển kỹ thuật
    • scintillation layer
  • lớp     noun bed; layer; stratum; coat lớp đất trên mặt a surface stratum....
  • phát     verb to distribute, to dispense, to issue, to deliver verb to...
  • sáng     adj bright, light buồng sáng light room màu sáng light...
  • phát sáng     (sinh vật) Photogenic ...
Câu ví dụ
  • There's a luminescent substrata below us.
    Có một lớp phát sáng dưới chúng ta.
  • This glow is strongest in the microwave region of the radio spectrum.
    Lớp phát sáng này mạnh nhất ở vùng sóng vi ba (microwave) của phổ sóng bức xạ.
  • This glow appears strongest in the microwave region of the radio spectrum.
    Lớp phát sáng này mạnh nhất ở vùng sóng vi ba (microwave) của phổ sóng bức xạ.
  • If a comet gets too close to the sun, some of the ice heats up and turns into a gas, creating a glowy layer and that famous tail.
    Nếu sao chổi quá gần mặt trời, một số băng tan và biến thành khí, tạo ra một lớp phát sáng và cái đuôi nổi tiếng.
  • At the light-emitting layer called the photosphere, it has a temperature of about 2,800 K, which is low enough for chemical compounds to form and survive.
    lớp phát sáng được gọi là quang quyển, nó có nhiệt độ khoảng 2.800 K, đủ thấp cho các hợp chất hóa học hình thành và tồn tại.
  • OLEDs can have either two layers or three layers of organic material; in the latter design, the third layer helps transport electrons from the cathode to the emissive layer.
    Các OLED có thể có hai hoặc ba lớp vật liệu hữu cơ; trong trường hợp thiết kế ba lớp thì lớp thứ ba sẽ giúp truyền tải các electron từ cathode tới lớp phát sáng (emissive layer).
  • The conductive layer inside the LED chip and the PN junction light-emitting layer form a high temperature of 1400 ° C or higher, and the high temperature causes partial melting into small holes, thereby causing LED leakage, darkening, dead light, short circuit, etc.
    Lớp dẫn điện bên trong chip LED và lớp phát sáng tiếp giáp PN tạo thành nhiệt độ cao từ 1400 ° C trở lên, và nhiệt độ cao gây ra một phần tan chảy thành các lỗ nhỏ, do đó gây ra rò rỉ, tối, chết, ngắn mạch và giống như đèn LED.